Air Swing Clamp Cylinder Bore:ø25-ø63 mm Pmax:10 kg/cm2
Product Introduction
- The product is ideal for mass production on a special purpose machine and jig on machining center. It will greatly upgrade production efficiency.
- When the air cylinder actuate, and the piston moves downward, the clamping arm will swing to a rated angle! Then it lowers until the workpiece is clamped securely.
- To avoid too fast motion a flow control valve is suggested to connect to the air inlet ports (A, B) on the swing clamp cylinder. Do not clamp workpiece while the clamp is swinging to avoid damaging on the cylinder barrel and internal parts.
- When increasing length of clamping arm is required, be sure do not exceed 1 .5 times of the ariginal length.
- The cylinder body is manufactured from aluminum allog. Surface is hard membrane treated for maximum smoothness on inside surface and long service life.
Ordering Code
Specifications
Single Side Swing Clamp
Double Side Swing Clamp
Clamping Arm Mounting Methods
Clamping Arm Removing Methods
Line type Bore:ø25-ø63 mm Pmax:10 kg/cm2
Dimensional table
Manifold with flow control Bore:ø32-ø63 mm Pmax:10 kg/cm2
Dimensional table
With magnetic induction Bore:ø25-ø63 mm Pmax:10 kg/cm2
Dimensional table
Flange type / Threaded body Bore:ø32-ø63 mm Pmax:10 kg/cm2
Dimensional table
Online Inquiry
